Samsung Syncmaster Sa350 Specs Code Version And

Troubleshooting 5.

Wiring Diagram S22A350H S23A350H S24A350H S27A350H.

Feature Specifications.2-1 2-2.

Disassembly and Assembly This section describes the disassembly and reassembly sequences for this monitor.

Warning: As this monitor has parts that are sensitive to static electricity, be careful when handling them.

Disassembly Caution: 1.

Turn the monitor off before beginning the disassembly process.

Remove the main PCB from the SHIELD- HOLDER.

We get the PBA. Reassembly procedures are in the reverse order of disassembly procedures.

Caution: Before servicing units covered by this service manual, read and follow the Safety Precautions section of this manual.

Note: If unforeseen circumstances create conflict between the following servicing precautions and any of the safety precautions, always follow the safety precautions.

Keep the power cord away from any heat emitting devices, as a melted covering may cause fire or electric shock.

Do not place the product in areas with poor ventilation such as a bookshelf or closet.

No Remark DVI to HDMI Cable BN39-01353B Samsung Electronics Service center HDMI Cable BN39-00641A.

Troubleshooting Set custom mode as follows before beginning a repair.

Resolution: 1920 X 1080 H-frequency: 67.5 kHz V-frequency: 60 Hz If the screen is blank, check whether the power cord is connected correctly.

When the Power Does Not Turn On - When turning on the Power button after connecting the power cable, the LED at the front of the Symptom monitor does not operate.

Check the IC604 power fuse and the IC604 output power.

Check the connections for the CN601 and the Main board inside the monitor.

When the screen is blank (Analog) Symptom - Even though the LED power turns on, the screen is blank when connecting the VGA cable.

Check the D-sub cable connections.

Major checkpoints - Check whether the LVDS cable is connected correctly to the panel.

Check whether the lamp connector of the panel is connected correctly to the Main board.

When a blank screen is displayed (HDMI) Symptom - Even though the LED power turns on, the screen is blank when connecting the HDMI cable.

Check the HDMI cable connections.

Check whether the lamp connector of the panel is connected correctly to the Mainboard.

Error Examples and Actions Error Appearance Symptoms and Actions Remarks Symptom: HDMI signals are not recognized.

Cause: This error occurs because the PC cannot recognize the mode information since the HDMI DDC is not input to the monitor.

Samsung Syncmaster Sa350 Specs Code Version And

Check the MCU code version and checksum after entering SVC Mode.

Entering SVC Mode - Adjust the Brightness and Contrast values to 0.

Hold down the Enter button for five (5) seconds.

The SVC Function OSD is displayed.

Service Function Monitor On Time: 13 Hr Panel Ch.

No.: On Time: 13 Hr Cycle Auto Auto Pixelshift PixeShift Country English HotPlug Time Service Function Monitor On Time: 13 Hr.

When a problem occurs: The Blank screen and No Power errors may occur.

Cables LVDS 30P FFC cable BN96-13722P (S27A350H) BN96-13722X (S22A350H) BN96-13227V (S23A350H) Code BN96-13722S (S24A350H) Photo.